Service
Machine Troubleshooting & Retrofits
Find the fault, fix the cause and replace what is obsolete before it stops the line again.
Intermittent stops are the expensive ones. We work from evidence: fault logs, trends and what changed, instead of swapping parts until it runs.
When the root cause is an obsolete controller, HMI or drive, we plan the replacement so it happens in a scheduled window instead of during a breakdown.
What we do
- On-site and remote fault finding on PLC-controlled equipment
- Intermittent stops, communication dropouts and drive faults
- Replacement of obsolete PLCs, HMIs and drives
- Program backups and recovery of missing documentation
- Sensor, actuator and safety-device replacement planning
- Health checks that list what will fail next and what to stock
What you get
- A written cause, not only a restart
- Current backups of every program on the machine
- A ranked list of obsolescence risks
Questions about machine troubleshooting & retrofits
What should we send you when a machine is down?
The exact fault text, the controller and drive models, a photo of the panel and what changed recently. That is usually enough to start remotely.
Do you offer a support agreement?
Yes. Plants that want a known response time and periodic backups can set up a monthly support plan after a first visit.
Is it worth retrofitting an old machine?
If the mechanics are sound, new controls usually cost a fraction of a new machine and remove the parts you can no longer buy. We give you both numbers.
Need help with machine troubleshooting & retrofits?
Tell us what the machine does today and what you want it to do.